The purposes of this study were to compare the effects of one or two applications of all-in-one adhesives on microtensile bond strengths (µTBS) to unground enamel and to investigate the morphological changes in enamel surfaces treated with these adhesives using a scanning electron microscopy (SEM).

Twenty-five noncarious, unrestored human mandibular molars were used. The unground enamel surfaces were cleansed with pumice. The following adhesives were applied to lingual, mid-coronal surfaces according to manufacture's directions; Clearfil SE bond in SE group, Adper Prompt L-Pop™1 coat in LP1 group, 2 coats in LP2 group, Xeno® III 1 coat in XN1 group, and 2 coats in XN2 group. After application of the adhesives, a hybrid light-activated resin composite was built up on the unground enamel. Each tooth was sectioned to make a cross-sectional area of approximately 1.0 mm² for each stick. The microtensile bond strength was determined. Each specimen was observed under SEM to examine the morphological changes. Data were analyzed with one-way ANOVA.

The results of this study were as follows;

1. The microtensile bond strength values were; SE (19.77±2.44 MPa), LP1 (13.88±3.67 MPa), LP2 (14.50±2.52 MPa), XN1 (14.42±2.51 MPa) and XN2 (15.28±2.79 MPa). SE was significantly higher than the other groups in bond strength (p < 0.05). All groups except SE were not significantly different in bond strength (p < 0.05).

2. All groups were characterized as shallow and irregular etching patterns.