In this study we measured the amount of light energy that was projected through the tooth material and analyzed the degree of polymerization by measuring the surface hardness of composites. For polymerization, Optilux 501 (Demetron, USA) with two types of light guide was used: a 12 mm diameter light guide with 840 mW/cm² light intensity and a 7 mm diameter turbo light guide with 1100 mW/cm².

Specimens were divided into three groups according to thickness of penetrating tooth (1 mm, 2 mm, 0 mm). Each group was further divided into four subgroups according to type of light guide and curing time (20 seconds, 40 seconds). Vickers'hardness was measured by using a microhardness tester. In 0 mm and 1 mm penetrating tooth group, which were polymerized by a turbo light guide for 40 seconds, showed the highest hardness values. The specimens from 2 mm penetrating tooth group, which were polymerized for 20 seconds, demonstrated the lowest hardness regardless of the types of light guides (p < 0.05).

The results of this study suggest that, when projecting tooth material over a specified thickness, the increase of polymerization will be limited even if light intensity or curing time is increased.

Citations

Citations to this article as recorded by  

• Comparison of Flexural Strength According to Post-Curing Treatment Time of Cast Resin Printed by 3D Printing Method
  Jihyun Kim
  International Journal of Clinical Preventive Dentistry.2024; 20(4): 170.     CrossRef
• Comparison of Surface Microhardness of the Flowable Bulk-Fill Resin and the Packable Bulk-Fill Resin according to Light Curing Time and Distance
  Hyung-Min Kim, Moon-Jin Jeong, Hee-Jung Lim, Do-Seon Lim
  Journal of Dental Hygiene Science.2023; 23(2): 123.     CrossRef
• Comparison of polymerization by time of light curing for dental 3D printing
  Dong-Yeon Kim, Gwang-Young Lee
  Journal of Korean Acedemy of Dental Technology.2022; 44(3): 76.     CrossRef
• Comparative analysis of the flexural strength of provisional restorative resins using a digital light processing printer according to the post-curing method
  Young-Dae Park, Wol Kang
  Journal of Korean Acedemy of Dental Technology.2020; 42(4): 341.     CrossRef